How To Open A Nail Glue Bottle That Is Stuck: Tips and Tricks

Oleh Olga Orn May 20, 2023 Post a Comment

You're all set to give yourself a beautiful manicure or pedicure, but when you go to open your nail glue bottle, it's stuck! Don't worry, we've all been there. It can be frustrating and time-consuming trying to pry open the cap of a stubborn nail glue bottle. In this article, we'll provide tips and tricks on how to open a nail glue bottle that is stuck.

15 Ways To Open A Nail Glue Bottle That Is Stuck

1. Warm Water

Place the bottle of nail glue in a bowl of warm water for a few minutes to loosen up the glue. Use a towel to dry the bottle and try to open it again.

2. Rubber Gloves

Wearing rubber gloves will increase your grip on the bottle and make it easier to twist off the cap.

3. Petroleum Jelly

Apply petroleum jelly around the rim of the bottle cap to help break the seal and make it easier to open.

4. Tap The Cap

Tap the bottom of the bottle on a hard surface to loosen up the glue and release any air bubbles. Then, try to open the cap again.

5. Use A Rubber Band

Wrap a rubber band around the cap of the nail glue bottle and twist it to gain more traction and grip.

6. Use Pliers

Use pliers to grip onto the cap and twist it open. Be careful not to apply too much pressure and crack the bottle.

7. Use A Towel

Wrap a towel around the cap of the nail glue bottle and twist it open. This will give you a better grip and protect your hands from slipping.

8. Refrigerate

Place the nail glue bottle in the refrigerator for a few minutes to cool down the glue and loosen up the cap. Then, try to open it again.

9. Use A Knife

Carefully insert a knife under the rim of the cap and twist it open. Be careful not to puncture the bottle or hurt yourself.

10. Use Hot Water

Run hot water over the cap of the nail glue bottle for a few seconds to heat up the glue and make it easier to open.

11. Use A Bottle Opener

Use a bottle opener to pry open the cap of the nail glue bottle. This will give you more leverage and help break the seal.

12. Twist And Pull

Twist the cap back and forth while gently pulling it upwards to break the seal and release the glue.

13. Use Vinegar

Dip a cotton ball in vinegar and apply it around the rim of the bottle cap to help break the seal and make it easier to open.

14. Use Heat

Use a hair dryer to heat up the cap of the nail glue bottle for a few seconds to loosen up the glue and make it easier to open.

15. Use Dish Soap

Apply dish soap around the rim of the bottle cap to help break the seal and make it easier to open.

Opening a nail glue bottle that is stuck can be frustrating, but there are many ways to do it. From warm water to vinegar, we've provided 15 tips and tricks on how to open a nail glue bottle that is stuck. Remember to be patient and gentle when trying to open the bottle, and always be careful not to hurt yourself.

Frequently Asked Questions

1. Is it safe to use a knife to open a nail glue bottle?

It is not recommended to use a knife to open a nail glue bottle as it can be dangerous and may cause injury. Use alternative methods such as warm water or rubber gloves instead.

2. How long should I leave the nail glue bottle in the refrigerator?

Leave the nail glue bottle in the refrigerator for about five minutes to cool down the glue before attempting to open it again.

3. Can I use pliers to open a nail glue bottle?

Yes, you can use pliers to grip onto the cap and twist it open. However, be careful not to apply too much pressure and crack the bottle.

4. Will hot water damage the nail glue?

No, hot water will not damage the nail glue. It will only heat up the glue and make it easier to open.

5. Can I use dish soap on the brush of the nail glue bottle?

No, do not use dish soap on the brush of the nail glue bottle as it may damage the brush and affect the quality of the glue.

6. What is the best way to prevent a nail glue bottle from getting stuck?

Make sure to always clean the rim of the bottle after using nail glue and store it in a cool, dry place to prevent the glue from drying up and sealing the cap shut.